IMPORTANT:
|
NOTE: Before attempting to proceed using this information, please review this document and make sure you are in the right section: Chan-SIP or Chan-PJSIP |
If you do not wish to use G.729 codec on your FreePBX, please ensure that your trunk configuration is only offering support for G.711u-law on your Flowroute trunk. The codec settings are modified in your FreePBX configuration.
If you will not be using G.729 on your PBX; you can use the below steps to act as a guide in disabling this codec.To disable G.729 on FreePBX
- Log onto your FreePBX administration panel.
- In the navigation pane, click Connectivity, click Trunks, and then click <Your Flowroute Trunk> to open your Flowroute trunk page.
- Locate the Outgoing Settings section.
-
In the PEER Details section, replace any instance of allow= with:
disallow=all allow=ulaw
-
When completed, the PEER Details section should resemble the following:
-
Click Submit Changes, and then click Apply Config.
Your FreePBX will now support only G.711u-law.