Skip to main content
Flowroute

Configure Cisco/Linksys SPA or PAP2T ATA

This article describes configuring Cisco/Linksys SPA or PAP2T ATA for use with Flowroute. It can also be used for configuring the Cisco/Linksys SPA2102 and other similar ATAs.

Before you begin

Have the following before configuring the system: 

To configure Linksys/Cisco PAP2T ATA:

  1. In the upper-right corner of the UI, click the Admin Login.

  2. Click Line 1 on the menu. 

    The following page appears: 

     
  3. From the Line Enable drop-down list box, select yes.
  4. Enter 5060 for the SIP Port

    NOTE: If you experience issues with the port, you can use the following alternate port: 5160.

  5. In the Proxy enter the following proxy address: sip.flowroute.com.
  6. From the Register drop-down list box, select yes
  7. In both the Display Name and User ID fields, enter your Flowroute telephone number in an E.164 format, which is a number formatted as 1+area code+7-digit number with no spaces between numbers—for example, 12065551234.
  8. In the Password, enter your SIP Credentials password, found on the Interconnection/Status & Settings page of Flowroute Manage.
  9. In the Auth ID field, enter your Username & Auth Username, found on the Flowroute Manage Interconnection page.
  10. In the Password field, enter your SIP Credentials password, found on the Interconnection/Status & Settings page of Flowroute Manage.
  11. From the Preferred Codec drop-down list box, select G711U for best results.
  12. Make sure all other settings are set to their defaults, and then click Save Settings.
  • Was this article helpful?