Skip to main content
Flowroute

Configure sipXecs

This article describes configuring sipXecs to work with your Flowroute telephone numbers.

Before you begin

To configure sipXecs:

  1. Log on to your sipXecs system.
  2. In the navigation pane, click Configuration.
  3. Enter your Name and Address as shown:
     

IMPORTANT: The Address field must use the SIP Registrar / Proxy from your Flowroute SIP credentials, sip.flowroute.com.

  1. Click Apply.
  2. In the navigation pane, click Caller ID.
     
  3. Click Apply.
  4. In the Default Caller ID field, enter the automatic number identification (ANI) you want to pass. 

NOTE: Although Flowroute does not restrict the Caller ID your system sends, ensure that your system sends a caller ID which abides by your local, state and federal laws.

  1. In the navigation pane, click Dial Plan.
  2. In the Prefix field, add the dialing format you need. 

NOTE: Keep in mind that Flowroute uses the E.164 format for dialing. For additional information regarding the E.164 format, see What dialing format should I use when sending calls?

  1. Click Apply.
  2. In the navigation pane, click ITSP Account, and enter your Flowroute SIP Credentials. 
  3. Click Apply, and then click OK.
  • Was this article helpful?