Technical Configurations

Prepend your Tech Prefix to use IP-Based Authentication in FreePBX

This article describes the steps required to prepend your Flowroute Tech Prefix to dialed numbers in order to use IP-Based Authentication in FreePBX. Dialed numbers are set up using the following format: ...

Read Article

Configure an Inbound Route in FreePBX

To receive inbound calls on your FreePBX system when your Flowroute Direct Inward Dial (DID) is dialed, you must have an inbound route configured. This is required in addition to ensuring your DID points to a v...

Read Article

Configure sipXecs

Before you begin Have your Flowroute SIP Credentials. These can be found on the Interconnection > Status & Setup page on your Flowroute account. To configure sipXecs: Log on to you...

Read Article

Twilio SIP Gateway

Using Flowroute as your carrier with Twilio Programmable Voice features is quick to setup; just follow the steps below to start leveraging the HyperNetwork with Twilio Programmable Voice. Login to your Twi...

Read Article

Set an Outbound Caller ID in the 3 CX 12 Telephone System

This guide describes setting up outbound caller ID on 3CX in a Windows environment using 3CX version 12. To set the outbound caller ID in 3CX 12 Open the 3CX Phone System Management Console. In the left...

Read Article

Set up Flowroute in Bria iPhone Edition for iOS 12

This article describes setting up your Flowroute telephone number to work with Bria iPhone Edition - VoIP Softphone SIP Client on iOS 12. NOTE: This article covers setting up a Flowroute account only on ...

Read Article