System Configuration

Set up the Patton SmartNode VoIP Gateway

This article describes setting up the Patton SmartNode Gateway. Before you begin: You will need your Flowroute SIP Credentials. These can be found on the Interconnection > Status & Settings pag...

Read Article

Configure an Asterisk PBX

This article is intended for use with a base Asterisk installation, with no FreePBX, and values set to their defaults. This configuration was created and tested on Asterisk 13.3.0 on CentOS 6.7. It should work ...

Read Article

Configure Outbound Rules for the 3CX 14 and 15 Phone Systems

The following article describes configuring outbound rules for your Flowroute SIP trunk for for 3CX version 14 SP 2 PBX phone system and the 3CX version 15 phone systems. To configure outbound rules for your F...

Read Article

Configure the MItel MiVoice Business 7.2

The attached guide describes programming a MiVoice Business 7.2 to interconnect with Flowroute SIP Trunking.

Read Article

FreeSWITCH 1.7: Compatibility Known Issue

FreeSWITCH 1.7 requires the following variable be added to vars.xml. If not added, codecs will not be offered properly by FreeSWITCH. set/media_mix_inbound_outbound_codecs=true/

Read Article

Configure the Grandstream - IPPBX UCM

This article describes configuring Grandstream - IPPBX UCM6102/6104 to work with Flowroute: To configure the Grandstream - IPPBX UCM6102/6104: Connect the analog telephone to the PBX through the FXS1 port...

Read Article

Configure Ubiquiti UniFi VoIP

Documentation for helping you set up and configure your Ubiquiti UniFi VoIP system can be found at the Ubiquiti UniFi website.

Read Article

Configure AudioCodes Mediant E-SBC between Flowroute and Skype for Business

The attached document describes the configuration setup between Skype for Business Server and Flowroute SIP Trunk using an AudioCodes Mediant E-SBC

Read Article

Configure Epygi QX IP-PBX Configuration Guide

The attached document describes configuring the Epygi QX IP PBXs for Flowroute SIP trunks.

Read Article

Switchvox PBX Software Issue: Flowroute Tech Prefix Displays for the Caller ID

The following software issue was found in with the Switchvox version 6.3.2 by Digium. Issue: Caller ID shows the Flowroute Tech Prefix. Flowroute customers using Switchvox identified a Switchvox issue...

Read Article