System Configuration

Set a Dial Plan for Outbound Calling and IP-based Authentication in Asterisk

To place outbound calls in Asterisk systems, you will need to configure the correct dial plan settings in your extensions.conf file, an example of which can be found at the end of this article. This article ...

Read Article

Set an Outbound Caller ID in the 3 CX 12 Telephone System

This guide describes setting up outbound caller ID on 3CX in a Windows environment using 3CX version 12. To set the outbound caller ID in 3CX 12 Open the 3CX Phone System Management Console. In the left...

Read Article

Add DIDs in the 3CX 14 Telephone System

The following article describes adding DIDs for the 3CX Phone System Version 14 Service Pack 2. Before you begin To receive inbound calls to your DIDs in 3CX, you will first need to have Flowroute se...

Read Article

Set up Flowroute in Bria iPhone Edition for iOS 10

This article describes setting up your Flowroute telephone number to work with Bria iPhone Edition - VoIP Softphone SIP Client on iOS 10. NOTE: This article covers setting up a Flowroute account only on ...

Read Article

Configure 3CX Softphone for Windows

This article describes configuring your 3CX Softphone for Windows for use with your Flowroute account. Before you begin You will need your Flowroute SIP credentials. These can be found on the Intercon...

Read Article

Configure an Inbound Route in FreePBX

To receive inbound calls on your FreePBX system when your Flowroute Direct Inward Dial (DID) is dialed, you must have an inbound route configured. This is required in addition to ensuring your DID points to a v...

Read Article

Prepend your Tech Prefix to use IP-Based Authentication in FreePBX

This article describes the steps required to prepend your Flowroute Tech Prefix to dialed numbers in order to use IP-Based Authentication in FreePBX. Dialed numbers are set up using the following format: XXXX...

Read Article

Configure an Outbound Route Dial Pattern for FreePBX

The following article describes configuring the FreePBX for Flowroute through the FreePBX UI. To configure an outbound route dial pattern: In the FreePBX UI, click Connectivity, and then click Outbound Ru...

Read Article

Configure Bria or X-lite Softphone for a PC or Mac

The following steps describe configuring your X-Lite softphone to connect directly to Flowroute for sending and receiving calls. Before you begin You will need your Flowroute SIP credentials. These ...

Read Article

Add Flowroute as a SIP Gateway in the Barracuda Phone System

This article describes adding Flowroute as the SIP Gateway in a Barracuda phone system. Before you begin Have your Flowroute SIP Credentials and Tech Prefix. These can be found on the Interconnecti...

Read Article